I hope this is okay to post here.  I stumbled upon a post that helped me figure out how to use a bandfuse guitar cable with Rocksmith on OSx Mac.  Without any problems like latency or noise.  No hack files needed at all.

 

1 Plug in your bandfuse cable

2 Go to your applications folder, utilities, and run Audio MIDI Setup

3 Click the little + in the lower left to create a new Aggregate Device

4 In the Aggregate Device select the BANDFUSE USB Guitar ADAPTER, I used the default volume level .375 and dB 5.939

4 Rename the aggregate device to "Rocksmith USB Guitar Adapter"

5 Right click the Rocksmith adapter, and select "Use this device for sound input"

5 Restart steam

6 Start Rocksmith

7 go and calibrate and tune your guitar

 

 

I tried a CM108 guitar USB interface I orderd from amazon first and had tons of noise and crackling.  When I switched to the Bandfuse cable all my problems went away!

 

Is it possible in Windows 10?

@@alvarero, for windows you need NoCable patch for that

No Cable patch works fine.  However I did also find a way to rewrite the firmware on the cable CM108 so it works for PC.  I just got a programmer this week and I'll see if I can figure it out.

@@fatcat, timewaste unless you'd like to play it at consoles, where you can't change vid\pid
anyway it's exp+ for you if you wanna know more about firmware :)

Actually let me clarify. No cable patch works fine if you use mic or line input and connect with an audio cable.  However I found I had issues with noise and had issues occasionally.  I cant remember but I think no cable didn't work for me with 2 players.  One needed to be a real cable.